Antari M-8 Mode D'emploi page 11

* Receiver:
The receiver is tested and pre-attached to the panel of each M-31. Please do not try to
remove it. The receiver responds to up to 5 different transmitters that are registered with the
machine. The included transmitter has been registered to the machine before shipping. It
can be directly operated without any start-up setting.
-Registering transmitters
To operate the machine with a different transmitter than the included one, or to operate it
with up to 5 different transmitters, each transmitter must be registered in advance. For this
purpose, turn on the machine. When the display indicates »Wireless Setup«, press the
button "A" 1 second on each transmitter. Thus the previous transmitters are cleared from the
memory of the receiver. The setting must be completed within 15 seconds after turning on
the machine. Then the machine will automatically exit the transmitter setting mode. The
display shows »Wireless Setup OK«. At this point, no further transmitter can be added.
If no transmitter is registered when the machine is switched on, the memory of the receiver
will keep the record of the previous operation.
Setting Example 1:
In order to register several transmitters with a machine, turn on the machine. When the
display indicates »Wireless Setup«, press the button "A" 1 second on each transmitter within
15 seconds to establish the signal transmission.
11