Ryobi APR04 Manuel D'utilisation page 23

TROUBLESHOOTING
If these solutions do not solve the problem contact your authorised service dealer.
PROBLEM POSSIBLE CAUSE
1. Check chain tension for
overtight condition.
Bar and chain
2. Chain oil tank empty.
running hot and
smoking. 3. Dull chain.
4. Chain installed backwards.
1. Chain tension too tight.
Motor runs, but
2. Check guide bar and chain
chain is not
assembly.
rotating.
3. Check guide bar and chain for
damage.
English(Original instructions)
SOLUTION
1. Tension chain. Refer to "Chain Tension"earlier in this
manual.
2. Check oil tank.
3. Sharpen or replace as needed.
4. Ensure cutting teeth of chain are oriented in proper
direction.
1. Retension chain, Refer to "Chain Tension" earlier in this
manual.
2. Refer to "Replacing the Bar and Chain" earlier in this
manual.
3. Inspect guide bar and chain for damage.
21