Stiga PTO Manuel D'utilisation page 48

1
4
5
– Keep the transmission belt (13) raised,
and push the accessory or move the ma-
chine forward until the arms (5) are fully
inserted in the tubes (4). If you encoun-
ter problems during this procedure, apply
some grease to the tubes and move the
lifting lever (3) slightly to ease insertion of
the arms.
12
13
– First wind the belt (13) around the pulley
(12), then reposition it so it rests inside the
tightener (14).
13
14
– Restore the position of the belt guide (11)
on the lower section of the machine, mak-
ing sure the terminal is correctly inserted
in its seat.
– Fully tighten the two knobs (1).
11
EN 4
13
5 4
12
2.3 DISASSEMBLY OF ACCESSORIES AND
RESETTING OF PRIMARY FUNCTIONS
– Lower the accessory.
– Perform the operations described above for
each interface version in the reverse order.
WARNING!
the arms (5) do not work free from their
seats which can cause uncontrolled move-
ment of the accessory and lifting lever,
and risk of personal injury.
1
Lifting system with
Power Take-Off (PTO)
WARNING!
cooled down before commencing dis-
assembly.
– It is recommended to start by releasing the
belt (13) from the tightener (14) to make it
easier to remove the pulley (12).
– Lower the lifting lever (3) (
possible.
– Insert the screw (21) in the hole (22) and
fully tighten the nut (23); this acts as a safety
element as it blocks the lever (3) in the fully
lowered position, avoiding accidental move-
ments the next time it is used.
21 22
– ALWAYS replace the front bumper (2) and
secure in place using the two knobs (1).
Assembling the front bumper protects the
interface and reduces the risk of accidental
contact with the hot surfaces of the silencer.
1
Pay attention to ensure
Wait until the belt has
3.1) as far as
23
2 1