Stiga PTO Manuel D'utilisation page 45

TRANSLATION OF THE ORIGINAL INSTRUCTIONS
TABLE OF CONTENTS
1. SAFETY REGULATIONS ......................... 2
2. CONNECTION AND DISASSEMBLY
OF ACCESSORIES ................................. 3
3. USING THE INTERFACE ......................... 5
4. STORAGE AND MAINTENANCE ........... 6
INTRODUCTION
PRESENTATION
Dear Customer,
first of all, we would like to thank you for choos-
ing our products and we hope that, with the
application of this interface, it fully meets your
expectations and that you will be even more
satisfied with the use of your machine.
Please remember that it must be used in strict
accordance with the instructions provided in
this manual, so as to avoid compromising the
overall safety of the machine and the accesso-
ries connected to it.
This manual, together with the Instruction
Manuals of the machine and connected acces-
sories, forms an integral part of the ancillary
documentation, aimed at assuring correct, se-
cure and efficient use in the various conditions
of use; keep it handy so that it can be consulted
at any time and pass it on to the purchaser if
you resell the machine.
The interface installation must always be
carried out by qualified personnel at a spe-
cialized center.
In case of any doubts, do not hesitate to contact
your Retailer. And now enjoy your work!
DESCRIPTION AND SCOPE
OF APPLICATION
This interface is designed and built to provide a
connection system to be used for the assembly
of supplementary accessories on the ride-on
mower.
The interface consists of:
– Lifting System
– Power Take Off (PTO) for the accessories
that require mechanical drive
Intended use
Assembly of compatible supplementary acces-
sories, aimed at extending the possibilities of
use of the machine.
Improper use
Improper use refers to any assembly on ma-
chines not included in the list of applicability or
the connection to incompatible equipment or
accessories.
Improper use will invalidate the warranty and
relieve the Manufacturer from all liabilities,
where the user will consequently be liable for all
expenses deriving from damage or injuries to
himself and others.
Connection and compatibility
of the interface
This interface can only be connected to ma-
chine models bearing the following abbrevia-
tions on the identification plate:
NJ (in the various versions)
TC (in the various versions)
TS - TX
Compatibility checks on the accessory to
be connected to the interface must verify
that the assembly, use and disassembly can
be performed without any need for adapta-
tions or modifications to the provisions of the
Manufacturers.
EN 1