Suction Lance, Continuous, For Gamma/ X, Gamma/ Xl And Dulco Flex Control Dfxa; Product Identification; Safety; General - ProMinent 1094379 Fiche Technique

Suction lance, continuous, for gamma/ X, gamma/ XL and DULCO flex Control DFXa

1 Suction lance, continuous, for gamma/ X, gamma/ XL and
DULCO flex Control DFXa

1.1 Product identification

1.2 Safety

1.3 General

1.4 Uses

Part no.
1094379
1094380
1094382
CAUTION!
– The operator must take appropriate measures
to rule out any danger to personnel by the feed
chemicals. Pay attention to the material safety
data sheet for the feed chemical as well.
– The suction lance is not liquid-tight nor gas-
tight.
– Do not use the suction lance for flammable or
explosive liquids.
– Check and ensure the chemical resistance of
the wetted components.
The suction lance with continuous level measurement is configured
for 30-litre standard canisters (to fit screw lid OV61) and metering
pumps gamma/ X, gamma/ XL and DULCO flex Control DFXa.
For metering pumps gamma/ X GMXa, gamma/ XL GXLa and
DULCO flex Control DFXa.
The suction lance works very well with feed chemicals containing a
lot of water, such as diluted acids and alkalis, sodium-calcium
hypochlorite, ... .
(The dielectric constant ε
It does not work with feed chemicals, such as pure oil, fats, ... .
Take into account the resistance of the wetted materials and the
ProMinent Resistance List when selecting the feed chemical - see
the ProMinent Product Catalogue or visit our website.
Install the suction lance vertically in a 30-litre liquid storage tank or
smaller tank, preferably directly below the metering pump.
Push the suction lance as far as the base of the storage tank and
then screw the lid closed.
Hose connector
mm
6 x 4mm
12 x 9mm
8 x 5mm
must be higher than 30).
r
13