Electrical Connection; Settings On The Pump - ProMinent 1094379 Fiche Technique

Suction lance, continuous, for gamma/ X, gamma/ XL and DULCO flex Control DFXa
Protection against contact and mois‐
ture

1.7 Electrical connection

1
P_BE_0016_SW
Fig. 1: "Level" input of a pump

1.8 Settings on the pump

1.8.1 Calibration
Perc. liquid level
Specification
Medium temperature:
Rel. humidity, max:
* Do not allow the feed chemical to freeze in the suction lance
** non-condensing
Specification
Protection against contact and moisture:
according to EN 60529
Use the cable supplied to connect the suction lance to the level
input of the pump.
Product
3
Level sensor cable, 3 m
2
'Menu / Information è Settings è Inputs/outputs
Suction lance è continuous è ...'
è
'Menu / Information è Settings è Inputs/outputs
Suction lance è continuous è Calibrate è ...'
è
The suction lance with continuous level measurement can
measure the liquid level in a 30-litre canister with 2.5% precision.
The relevant secondary display of the gamma/ X, gamma/ XL or
DULCO flex Control DFXa indicates the liquid level, or the liquid
level can be reported via a pump by bus to the control panel.
It is possible to calibrate the continuous level measurement in this
sub-menu of the pump.
'Menu / Information è Settings è Inputs/outputs
Level measurement è continuous è Calibrate
è
Perc. liquid level è ...'
è
For instance with initial commissioning, immerse the suction lance
in the still fully filled storage tank and fix in place. Then under
'Calibrate' , set the 'Perc. liquid level' to '100 %' . Result: the pump
will always display 100 % with a full storage tank - providing the
size of the storage tank has not been changed in the meantime.
Value
-10 ... +50 °C *
95 % **
Value
IP66
Part no.
1082384
15