ProMinent 1094379 Fiche Technique page 16

Suction lance, continuous, for gamma/ X, gamma/ XL and DULCO flex Control DFXa
Electrodes
1.8.2 Configuration
16
1. 'Menu / Information è Settings è Inputs/outputs
Under
Level measurement' select 'continuous' .
è
'Percent liquid level' under 'Calibrate' .
2. Select
'Calib. "Liquid level"' display appears with 'Calibr. to
ð The
xx % liquid level' and a 'Push' symbol.
3. Immerse the suction lance in the feed chemical.
[dial] to set the required percentage for this level and
4. Use the
[dial] .
press the
ð The pump saves the value.
The application switches back to the Start menu.
5. Check whether the level measurement is working as
expected (e.g. in the "Liquid level" secondary display or on
your control panel).
'Menu / Information è Settings è Inputs/outputs
Level measurement è continuous è Calibrate è Electrodes
è
...'
è
'electrodes' in this sub-menu – this is a step
You can calibrate the
that is not normally necessary.
1. Remove the suction lance from the feed chemical.
'Electrodes' under 'Calibrate' .
2. Select
'Calibrate air values' display appears with a 'Push'
ð The
symbol.
[dial] .
3. Press the
ð The air value is calibrated.
'Calibrate medium' display appears with a 'Push'
The
symbol.
4. Immerse the suction lance in the feed chemical as far as the
holding claws.
[dial] .
5. Press the
ð The calibration process is completed.
6. Check whether the level measurement is working as
expected (e.g. in the "Liquid level" secondary display or on
your control panel).
'Menu / Information è Settings è Inputs/outputs
Suction lance è continuous è Configure è ...'
è
You need to enter the warning thresholds for the suction lance with
continuous level measurement and the required unit if necessary
into this sub-menu of the pump.
'Warning threshold level' as a % and press the
1. Enter the
[dial] .
'Error threshold level' as a % and press the [dial] .
2. Enter the
(Note: Ensure that the error threshold is below the warning
threshold.)