Hilti HIT-RE 500 V4 Mode D'emploi page 24

European technical assessment E T A - 2 0 / 0 5 4 1
English translation prepared by CSTB
Installation of Hilti Filling Set
Injection system Hilti HIT-RE 500 V4
Intended use
Installation instructions
Use Hilti Filling Set with standard nut. Observe the correct orientation of filling washer
and spherical washer.
The applied installation torque shall not exceed the values max. T
to Table B5.
Optional:
Installation of lock nut. Tighten with a ¼ to ½ turn. (Not for size M24.)
Fill the annular gap between the anchor rod and fixture with 1-3 strokes of a Hilti
injection mortar HIT-HY ... or HIT-RE ... .
Follow the installation instructions supplied with the Hilti injection mortar.
After required curing time t , the fastening can be loaded.
cure
Page 23 sur 61 | 0 4 / 0 9 / 2 0 2 1
given in in Table B1
inst
Annex B14