Quick CHC1202 M Manuel De L'utilisateur page 25

UTILITY
SENSOR TEST
LCD TEST
CLOCK BATTERY
SW VERSION
SET DEFAULT
CHECK FLASH
UTILITY
SW VERSION
SET DEFAULT
CHECK FLASH
CHECK EEPROM
CAN MESSAGE
EXIT
SENSOR TEST
SENSOR STATUS:
ON
SENSOR TEST
SENSOR STATUS:
OFF
SETTINGS MENU - UTILITY - LCD TEST
This function can be used to check correct operation of the LCD display»s pixels.
Once the data item has been confirmed from the utility menu, all the display pixels will be activated for 5
seconds; after which the system will go back to menu UTILITY.
CLOCK BATTERY
CLOCK BATTERY
X.XX VDC
SETTING THE CHAIN COUNTER
SETTINGS MENU
UTILITY
This option allows the user to perform procedures to check and control
the chain counter operation.
The UTILITY sub-menu appears as shown below:
Select data items from sub-menu
Press this key to go to the menu shown in REVERSE; if EXIT has been
selected the system goes back to the SETTINGS menu.
SETTINGS MENU - UTILITY
SENSOR TEST
This function can be used during installation or to check that the lap
sensor works properly. If the sensor detects the magnet, ON is dis-
played and the buzzer sounds; otherwise OFF is displayed and the
buzzer does not sound.
Go back to UTILITY
SETTINGS MENU - UTILITY
CLOCK BATTERY
This function displays the voltage of the clock»s buffer battery.
Go back to UTILITY menu.
GB
25