Quick CHC1202 M Manuel De L'utilisateur page 22

SETTING THE CHAIN COUNTER
GB
SETTINGS MENU - CALIBRATION - GYPSY LAP
Use this option to set the measurement of the chain in one gypsy lap. To obtain this value, remove the
gypsy, wind the chain around it and then measure its length.
It is extremely important that the value set for GYPSY LAP is precise as it affects the
accuracy with which the length of the lowered chain is measured
GYPSY LAP
SET VALUE:
10.0 CM
GYPSY LAP
SET VALUE:
10.0 INC
MAGNETS NUMBER
SET VALUE:
1
22
GYPSY LAP
If the unit of measurement is set to METERS, the settable values are
from 1.0 to 999.9 cm (default: 10 cm).
Increase
Decrease
Confirm value and go back to CALIBRATION menu.
If the unit of measurement is set to FEET, the settable values are from
1.0 to 999.0 inc (default: 10 inc).
SETTINGS MENU - CALIBRATION - NUMBER OF MAGNETS
Use this option to set the number of magnets installed on the gypsy.
Selectable Values: 1 to 16. (default: 1).
Increase
Decrease
Confirm value and go back to CALIBRATION menu.
Consult the User»s
manual of the windlass
for more detailed
instructions on how to
remove and re-install the
gypsy.