Publicité
Les langues disponibles
Les langues disponibles
WINDLASS ELECTRIC DRIVE
Getting the anchor aweigh
To get the anchor aweigh press key
anchor reaches the desired position and then release it.
While moving up, the chain counter displays a window similar to the one
shown below:
It is also possible to get the anchor aweigh with an other electric control.
The chain counter will measure the length of the chain lowered in any case.
Lowering the anchor
To lower the anchor press key
anchor reaches the desired position and then release it.
While moving down, the chain counter displays a window similar to the one
shown below:
It is also possible to lower the anchor with an other electric control.
The chain counter will measure the length of the chain lowered in any case.
Automatic down function
This function can be used only if it was previously set and activated on the FUNCTIONS\AUTO DOWN
menu (see chapter SETTING THE CHAIN COUNTER).
ATTENTION: regular operation of the windlass has to be checked when moving down automatically
To lower the anchor automatically to the set depth, press keys
and
(DOWN) simultaneously for more then three seconds. Once the pro-
cedure has started, both keys can be released.
The chain counter will lower the anchor to the set depth.
While moving down automatically, the chain counter displays a window simi-
lar to the one shown below:
The automatic lowering procedure can be interrupted by pressing any key of the chain counter from
which the procedure was activated, by activating the up function from an external device (from another
chain counter or other control) or by shutting off the chain counter.
CHAIN COUNTER OPERATION
(UP). Hold the key pressed until the
(DOWN). Hold the key pressed until the
CHAIN UP
SPEED
CHAIN DOWN
SPEED
AUTO DOWN
(SELECT)
SPEED
GB
82 M / M
82M / M
82 M / M
13
Publicité
