Quick CHC1202 M Manuel De L'utilisateur page 24

GB
SETTING THE CHAIN COUNTER
AUTO CALIBRATE
SET VALUE:
METERS FEET
EXIT
AUTO CALIBRATE
PRESS
UNTIL 6M
DEPTH
PRESS
TO EXIT
AUTO CALIBRATE
PRESS
UNTIL 20FT
DEPTH
PRESS
TO EXIT
Once key (DOWN) is released the chain counter will stop the chain from moving down and automati-
cally set the following values:
GYPSY LAP
CM=600/number of laps counted
NUMBER OF MAGNETS=1
After which the following window will be displayed for two seconds:
AUTO CALIBRATE
END OF
PROCEDURE
24
SETTINGS MENU - AUTOMATIC CALIBRATION
Use this option to automatically calibrate the chain counter.
The first window regarding AUTOMATIC CALIBRATION is shown below:
Use this option to select the unit of measurement used to measure the
chain lowered. Selectable values: METERS or FEET.
Select the values available.
Confirm value and go to next window for AUTOMATIC CALIBRATION
procedure, if EXIT is selected the system goes back to menu SETTINGS.
This window tells the user the chain has to be lowered 6 meters (or
20 feet, depending on the unit of measurement selected) in an unin-
terrupted manner. The length of the chain unwound each lap can be
calculated according to the number of laps completed by the gypsy
(counted by the chain counter).
Not active
Chain down; it counts the number of gypsy laps.
Cancel procedure and go back to SETTINGS menu.
CM=240/number of laps counted
NUMBER OF MAGNETS=1
And the SETTINGS menu will be shown again.
GYPSY LAP