Hofmann monty 1270 smart Mode D'emploi page 58

58
ii-1
ii-2
ii-3
ii. Carriage instructions –
Uncrating instructions -
Moving the machine
Carriage instructions
The machine is crated in a corrugated box of
appropriate strength. The box is mounted on a
pallet.
Handling of the machine must be made with an
appropriate lifting device (fork lift) (Fig.ii-1).
The machine can be alternatively mounted on the
pallet with the column assembled. In such a case
the machine must be anchored to the transportation
vehicle with a belt of appropriate strength rolled
around the column (Fig.ii-2).
Uncrating instructions
Uncrate the machine paying attention when cutting
the plastic straps or during any other operation
which may be hazardous.
After removing the carton check for any visible
damage to the machine and its components.
In case of doubt call qualified personnel for
assistance.
The packing materials (plastic bags, polystyrene,
nails, screws, wood etc.) must be properly disposed
of. Place the above mentioned materials into a trash
container and dispose per local regulations.
ALWAYS WEAR GLOVES WHEN UNCRATING
THE MACHINE TO PREVENT SCRATCHES OR
ABRASIONS DUE TO CONTACT WITH PACKING
MATERIALS.
Moving the machine
In case the machine is to be moved from one
working place to another, proceed as follows:
Disconnect the machine from the air and electric
supply.
Remove from top of the cabinet and turntable all
objects that may fall during displacement and create
hazard.
Hold the machine as depicted in (Fig. ii-3). Use belts
of a length of mm 3000 (10ft) and a capacity of kg
500 (1100 lbs). Do not use metal ropes to lift the
machine.
Operator Manual