Typical Vent Installation - Napoleon STARfire Serie Mode D'emploi

venting
EN
A terminal shall not terminate directly above a sidewalk or paved driveway which is located between two single family dwellings
and serves both dwellings. Local codes or regulations may require different clearances.
Do not allow the inside liner to bunch up on horizontal or vertical runs and elbows. Keep it pulled tight. A 1¼" (31.8mm) air gap
all around between the inner liner and outer liner is required for safe operation.
This appliance is certifi ed for use with a power vent kit. Contact your local authorized dealer for more information.
2.1

typical vent installation

THE FIRST TWO FEET
OF OUTER 7" (178MM)
DIAMETER VENT PIPE FROM
THE APPLIANCE MUST BE
WRAPPED IN THE 1" (25MM)
THICK INSULATION SLEEVE
14" (356mm)
MIN.
38 7/16"
(976mm)
Refer to "VENTING" section.
10
W415-2372 / A / 11.14.19
WARNING!
(SUPPLIED).
18" (457mm)
MAXIMUM
52 7/16"
(1330mm)
PLUS RISE *
INSULATED
SLEEVE
16" (406mm)
MINIMUM
40 FEET
(12m)
MAXIMUM
3 FEET (0.9m)
MINIMUM
38 7/16"
(976mm)