10.2 Control Access - Napoleon STARfire Serie Mode D'emploi

Masquer les pouces Voir aussi pour STARfire Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

maintenance
EN
10.2
control access
Once the appliance has been framed and fi nished, control access can only be achieved by removing the access
panel from the inside right side of the fi rebox. The following sub sections take you through the steps of accessing
the control as if the appliance is installed.
*Prior to removing the control panel follow the "DOOR REMOVAL" process and then follow the media removal
instructions located under the "MAINTENANCE" section.
note:
It will be necessary to replace the gasket (W290-0238) for the access plate if the appliance has been previously
operated before removing the plate (W290-0238).
A.
Remove the media from the appliance, follow removal instructions under the " MEDIA REMOVAL"
section.
B.
Remove the right side brick / porcelain panel, follow removal instructions under the " BRICK /
PORCELAIN PANEL REMOVAL" section.
C.
To remove the glass media trays to remove the glass burner, follow removal instructions under the
"MEDIA TRAY" section (glass burner only).
D.
Remove the grate before removing the brick / porcelain panels, follow removal instructions under the
"GRATE REMOVAL" section (log burner only).
E.
To access the controls remove the 8 screws securing the access plate from inside the fi rebox.
F.
Care should be taken to ensure avoiding damage to the gasket.
G.
Reverse this process to install the control access. Ensure the access plate is well sealed to the appliance.
48
W415-2372 / A / 11.14.19
RIGHT SIDE
PRE INSTALLATION
ACCESS

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Starfire hdx35ntStarfire hdx35pt

Table des Matières