B Appendix - Flamepath - Videotec MAXIMUS MPXHD Manuel D'instructions

B Appendix - Flamepath

The maximum constructional gap (ic) is less than that required by Table 2 of EN 60079-1:2007 as detailed below:
FLAMEPATH
1. Between component drawings
BRT2MPXALBPAN e BRT2MPXTAPINF
2. Between component drawings
BRT2MPXALBTP e BRT2MPXBUT
3. Between component drawings
BRT2MPXALBTS e BRT2MPXBUT
4. Between component drawings
BRT2MPXALWIP e BRT2MPXBUST
Tab. 13
MNVCMPXHD_1607_EN
MAXIMUM GAP (MM) MINIMUM WIDTH (MM)
0.249 25.4
0.245 26.8
0.245 26.8
0.249 25.3
COMMENT
Cylindrical joint sup-
ported by bearings
Cylindrical joint sup-
ported by bearings
Cylindrical joint sup-
ported by bearings
Cylindrical joint sup-
ported by bearings
45