7.5 Decommissioning/disassembly
Before starting any work on the linear unit, any electric drives used must be prevented
from accidental switching on.
If a linear unit is installed in an oblique or vertical position, the guide carriage drive must be
secured against slipping during dismantling. The system is to be freed from any loads or forces.
Following a collision, the threaded spindle and the guide nut have to be replaced - even if there is
no visible damage.
7.6 Disposal and return
The linear unit must either be disposed of in an environmentally friendly way according to the
applicable policies and regulations, or returned to the manufacturer.
The manufacturer reserves the right to charge for disposing of this linear unit.
7. Life phases
43