Angelcare AC115 Manuel Du Propriétaire page 4

to cords and plugs, convenience receptacle, and
the point where they exit from the product.
15.10 Accessories - Only use attachments/
accessories specified by the manufacturer. DO
NOT place this product on an unstable cart,
stand, tripod, bracket or table. The product may
fall, causing serious injury to a child or adult and
serious damage to the product. Use ONLY with a
cart, stand, tripod, bracket or table recommended
by the manufacturer or sold with the product.
Any mounting of the product should follow the
manufacturer's instructions.
15.11 Unplug this appliance during lightning storms
or when not used for long periods of time.
15.12 Servicing - DO NOT attempt to service
this product yourself as opening or removing
covers (except battery doors) may expose you
to dangerous voltage or other hazards.
15.13 Replacement parts - When replacement
parts are required, be sure the replacement parts
specified by the manufacturer have the same
characteristic as the original part. Unauthorized
substitution may result in fire, electric shock or
other hazards.
15.14 Usage - This baby monitor is intended as
an aid. It is NOT a substitute for responsible and
proper adult supervision and should not be used
as such. Use this appliance ONLY for its intended
use as described in this manual.
15.15 Power Sources - Operate this product only
from the type of power source indicated on the
type plate of the adaptor. If you are unsure of the
type of power supply to your home, consult your
dealer or local power company.
15.16 Overloading - DO NOT overload wall
outlets, extension cords or integral convenience
receptacles as this can result in a risk of fire or
electric shock.
15.17 Object and Liquid Entry - NEVER push
objects of any kind into this product through
casing slots as they may touch dangerous voltage
points or short out parts that could result in a risk
of fire or electric shock. NEVER spill liquid of any
kind on the product.
15.18 Antenna - The antenna used for this
transmitter must be installed to provide a
separation distance of at least 7.9" (20 cm) from all
persons and must not be collocated or operating in
conjunction with any other antenna or transmitter.
15.19 Power Lines - An outside antenna system
should NOT be located in the vicinity of overhead
power lines or other electric light or power circuit,
or where it can fall into such power lines or circuits
as contact with them may be fatal.
15.20 WA R N I N G
Children have STR ANG LED in cords . Keep
adapter cords out of the reach of children (more
than 3 feet (1 meter) away). NEVER use Sensor
Pad(s) without the protective cord covering.
Check protective cord covering before each use.
Immediately discontinue use of Sensor Pad(s) if
protective covering is damaged or broken.
15.21 Interference - This monitor uses public
airwaves to transmit signals. The Parent Unit may
pick up signals or interference from other nursery
monitors in your area. Your monitor may even be
picked up by other households. To protect your
4
S t r a n g u l a t i o n H a z a r d
privacy, make sure both units are turned OFF when
not in use. If you experience interference, change
the channel on both units.
15.22 Vibration Source - When the monitor is in
use, DO NOT use a bedside crib, crib mobile or
other crib accessories that may produce vibrations.
Other sources of vibrations may include fans,
washing machines, loud music, etc. These sources
of vibration may interfere with the performance
of your Angelcare
not sound if it continues to detect any movement
other than your baby's. Be sure all vibration
sources are eliminated before using the monitor.
You may experience false alarms for several reasons.
The most common reason is the Nursery Unit has
not been turned OFF after you have removed your
baby from the crib. Another reason is the Sensor Pad
has not been placed under the mattress properly.
Be sure the Sensor Pad is on a flat, firm surface
with the printed side facing up. The sensitivity
level may also need to be adjusted. Refer to Step
5.4. Always be sure to immediately check on baby
whenever an alarm sounds.
15.23 Sensor Pad - Your Sensor Pad can be used
in any cot that is stationary. If the cot has a spring
or slat base, place a hard board between the cot
base and the Sensor Pad measuring at least 33 x
33 cm and 6 mm thick. Only use your Angelcare®
monitor in a stationary sleeping environment
such as a cot where the Sensor Pad can rest on
a completely flat, firm surface. The Sensor Pad
is made of plastic and does not permit the air to
circulate. Therefore, mildew build up could develop
underneath the mattress in the Sensor Pad area.
We suggest rotating the mattress regularly to
prevent any mildew.
16. I M P O R TA N T
RELATED TO USE OF BATTERIES
16.1 Use ONLY the type and size of batteries
specified in the owner's manual. There is a
risk of explosion if batteries are replaced
with an incorrect type.
16.2 Use ONLY AAA rechargeable batteries and/
or the AC Adapters provided for the Parent Unit.
You must use only rechargeable batteries in the
Parent Unit. DO NOT use alkaline batteries or you
will severely damage the unit.
16.3 Charge the batteries for 10 hours prior to first
use. Be sure to have the monitor in the OFF position
during this period. ONLY use the AC Adapters
included with your monitor.
16.4 DO NOT use these adapters with any other
equipments.
16.5 When unplugging the AC Adapter from the
—
Nursery Unit, be sure it is switched to the OFF
position. If it isn't, the unit will revert to battery
mode if batteries are installed.
16.6 DO NOT use rechargeable batteries in the
Nursery Unit. Use alkaline batteries ONLY.
16.7 DO NOT dispose batteries in fire. They may
explode. Check with local regulations for possible
special disposal instructions.
16.8 Exercise care in handling batteries in order
not to short out the batteries with conducting
materials such as rings, bracelets and keys.
Overcharging, short circuiting, reverse charging,
monitor and the alarm will
®
S A F E T Y I N S T R U C T I O N S