Angelcare AC115 Manuel Du Propriétaire page 23

Masquer les pouces Voir aussi pour AC115:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WEAK RECEPTION
• Bring units closer together.
• Change the position of one or both units.
• Place units on a flat surface away from baby's reach.
• Replace the batteries or recharge the Parent Unit.
STATIC, DISTORTION, INTERFERENCES (FROM OTHER
MONITORS, WIRELESS PHONES, WALKIE-TALKIES, ETC...)
• Rotate the Parent Unit or move it away from source of interference.
FEEDBACK (LOUD NOISES EMITTED FROM THE PARENT UNIT)
• Move units farther apart (at least 3 meters apart).
• Decrease volume on the Parent Unit.
THE PARENT UNIT SCREEN IS BLACK (PARENT UNIT IS OFF)
• Turn the Parent Unit back ON by pushing and holding the power button.
• Replace the batteries or recharge the Parent Unit.
SENSOR PAD LIGHT INDICATOR FLASHING RED
(MONITOR IS BARELY DETECTING MOVEMENT)
• Make sure there is no bedding between the mattress and the Sensor Pad.
• The Sensor Pad must rest on a completely flat and firm surface. If the crib has a spring
or slat base, place a hard board between the crib base and the Sensor Pad measuring
at least 13'' x 13'' (33 x 33 cm) thick.
• Make sure Sensor Pad is positioned as described under the setup requirements.
Sensitivity may need to be adjusted, refer to Step 5.4.
NO POWER
• Check or replace batteries.
• Make sure Monitor is ON.
NURSERY UNIT POWER ON INDICATOR (GREEN LIGHT) DOES NOT LIGHT UP
• Check connections or change to another electrical outlet.
• Press the Nursery Unit ON/OFF button for 2 seconds to turn the Nursery Unit ON.
E
N
23

Publicité

Table des Matières
loading

Table des Matières