Angelcare AC115 Manuel Du Propriétaire page 16

IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Adjust Sensor Pad sensitivity level.
• Turn OFF crib mobile, fans, loud music or anything else that may cause vibration.
TO STOP THE ALARM
Place your hand
back on the
mattress.
5.3 - PAUSING AND RESTARTING THE SENSOR PAD
Allows you to pause the Sensor Pad if you remove baby from the crib, e.g. for feeding or comforting.
Pause Sensor Pad
IMPORTANT
• If you do not pause the Sensor Pad, the alarm will sound if there is no movement after
20 seconds.
• Ensure to unpause the Sensor Pad before putting baby in the crib.
5.4 ADJUST THE SENSOR PAD SENSITIVITY LEVEL:
To ensure adequate monitoring of your baby's movements, you can adjust the sensitivity of the
Sensor Pad. Set a high sensitivity for a newborn and a lower sensitivity as baby grows and gains
weight. A thicker mattress will also need a higher sensitivity. Slide the Nursery Unit sensitivity
level button to select between low, medium or high level.
For optimal results begin with medium
sensitivity level, adjusting the sensitivity
by increasing or decreasing as required.
NOTE:
If you are experiencing false alarms,
adjust the sensitivity level.
16
OR
Press PAUSE button
on the Nursery Unit
OR
1) From the Parent Unit, press and
hold Pause Sensor Pad button
for at least 2 seconds.
OR
From the Nursery Unit, press
the Pause button
Press PAUSE
SENSOR PAD
button on the
Parent Unit