Tecno-gaz PEARL Manuel De L'utilisateur page 39

Put the master switch on the side, in position "I" (fg.4), the device is now ready to
be used.
1. Set the type of program through the button on the dashboard:
On display are the second required for the polymerization of protective dam.
At the end, the display shows the time of standard treatment of bleaching
(10 ').
On display are 10' (standard step) for the first phase of treatment
2. Varying the period of treatment using the keys and
pos.C and D fg.5
3. Turn on the lamp through the key pos.E fg.5.
4. If you want to stop treatment, press Pause/Stop pos.F fg 5.
5. If you want to stop finally treatment, press Pause/Stop.
6. If nothing is the lamp turns off when the cycle ends and begins a set period of
further cooling led off.
Operating and environmental limits:
Operating temperature
Humidity
Pressure
Preliminary polymerization pos.B fg.5.
Treatment of bleaching
Step in seconds for the program polymerization
Step in minutes for the program bleaching.
pos.A fg.5.
5 ÷ 30
10 ÷ 90
500 ÷ 1060
15
ENGLISH
°C
%
hPa.