Calibrate The Scanner; Notes On Battery Usage; Storing The Scanner; Technical Specifications - Kodak P811 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

C a l i b r a t e t h e S c a n n e r
If the scanned picture looks fuzzy or there are strange stripes on it, the scanner may need calibrating in order for the sensor to
resume its original precision.
Follow the instructions beginning on page 20 to clean the roller and the image sensor, and then follow the instruction in "Initial
Setup" on page 10 to prepare the scanner for scanning.
N o t e s o n B a t t e r y U s a g e
We recommend using Ni-MH rechargeable type batteries. Note that there is no battery charging function in the scanner.
Always ensure that the batteries are installed with the positive and negative terminals in the correct direction as shown in the
battery compartment.
Different types of batteries have different characteristics. Do not mix different types.
Do not mix old and new batteries. Mixing old and new batteries shorten battery life or causes chemical leaks from the old
batteries.
Chemicals which leak from batteries may cause skin irritation. If any chemical matter seeps out of the batteries, wipe it up
immediately using a dry cloth, and replace the batteries as soon as possible.
When the scanner indicates "battery low" in "ready for use" status, replace batteries before beginning a scan to avoid the
scanner from stopping during the scan.
S t o r i n g t h e S c a n n e r
If the scanner won't be used for a prolonged period of time, follow the instructions below to store the scanner for future use.
1. Disconnect the scanner from power supply.
2. Place the scanner and power adapter in a box or bag to keep them from accumulating dust.
3. Place it in a cool and dry place, inaccessible to small children.
4. After long-term storage, it is recommended that you clean and calibrate the scanner before use.
T e c h n i c a l S p e c i f i c a t i o n s
Specification
Media Type
Common Document Size
Actual Feed Slot Size
Length: 12 inches (304.8mm)
All manuals and user guides at all-guides.com
4. Slide the sensor cleaning swab to the left end of the output slot, and then remove it
from the slot.
 Store it in a safe place and protect it from dust.
Insert the calibration card as shown.
The scanner scans the pattern on the calibration card and perform calibration to the sensor inside
automatically.
 Make sure that the calibration card is inserted in the correct direction. Otherwise the calibration
won't work.
KODAK P811 Personal Photo Scanner
Photo/35mm negative filmstrips and slides
3.5"x5", 4"x6" 5"x7", and 8.3"x11.7""
(plastic sheath only supports 3.5"x5", 4"x6", and 5"x7")
up to 8.5x12"
Width 8.5 inches (216mm)
Customer Support: http://www.pandigital.net/kodaksupport
21

Publicité

Table des Matières
loading

Table des Matières