Feeding Filmstrips - Kodak P811 Guide De L'utilisateur

Auto Image Mirror/Flip
The scanner can detect the orientation of a filmstrip when the printed numbers on the edge of the filmstrip are in the
same orientation as the picture.
If you feed the filmstrip with the image mirrored or upside-down, the scanner automatically adjusts the scanned
image during the scan.
The following orientations would result in the same scanned image:
For example, the bottom image (above) is upside-down but the numbers are right-side up. If fed in this
orientation, the picture would not be rotated, resulting in the scanned picture remaining upside-down.
 The current recognition capability has difficulty distinguishing the direction of the number "3", "6", "8" and
"9". The number's position is near the edge of the film and can easily be worn out or damaged. When the
number on the edge cannot be detected in the expected position, or does not meet the required condition
above, the Auto Mirror/Flip function is disabled.

Feeding Filmstrips

1. Make sure that the feed slot is clear of any original, and that there is enough space behind the scanner for the filmstrip to
feed all the way through.
12 Customer Support: http://www.pandigital.net/kodaksupport
All manuals and user guides at all-guides.com
No rotation required
Auto mirrored
Auto flipped
If the numbers and image are not in the same orientation, or if numbers are damaged,
the auto mirror/flip function will not rotate the image.
2. Slide the paper guide lever all the way to the right side of the feed slot.
3. Insert the 35mm film adapter all the way into the feed slot until it snaps into place, being careful not
to bend the metal parts.
Wait until indicator lights are in the "Ready to use" status before proceeding.
4. Hold up the negative towards light, with the image facing you in normal orientation (not mirror or
upside down).
5. Insert the filmstrip into the 35mm
Negative adapter.
Final scanned image
Pay attention to the direction of
the filmstrip when inserting.