Kodak Easyshare Software For Macintosh; System Requirements; Install Easyshare Software; Uninstall The Easyshare Software - Kodak P811 Guide De L'utilisateur

K O D A K E A S Y S H A R E S o f t w a r e f o r M A C I N T O S H
After using Scan PC Software for KODAK Personal Photo Scanners to scan and store your pictures on your computer, you can
use EASYSHARE Software to organize, edit, print, and share your pictures online.

System Requirements

 Operating system: MACINTOSH OS X v10.6.x, MACINTOSH OS X v10.5.x, MACINTOSH OS X v10.4.x
 Intel Duo Core/G3 processor
 1.2GHZ or better/G3 processor speed
 128MB RAM
 200MB free hard disk space

Install EASYSHARE Software

1. Verify that your computer meets the system requirements.
2. Close all programs.
3. Disconnect all accessory devices from your computer. For example, digital camera, camera dock, printer dock, photo
printer, card reader, etc.
4. Insert the SD Memory Card into the scanner, and then connect the scanner to your computer.
5. Select
KODAKSCAN>KODAK>Software>KODAK_Scan_Mac_Software_Setup_VQ1.01\KODAK EasyShare
Mac>KodakEasyShare_v6_2.dmg
6. Use the feature in the software or go to
Help

Uninstall the EASYSHARE Software

1. Open a Finder window.
2. Click Applications, right-click EasyShare, and then select Move to Trash.
S c a n n e r M a i n t e n a n c e
Cleaning the Scanner
In order to maintain the scanned image quality and prevent dust accumulation, it is recommended that you clean the
scanner (outer casing, image sensor and roller inside the scanner) approximately every 50-100 scans.
Clean the scanner also if:
 vertical lines or stripes appear on the scanned picture
 photos or film will not feed
Use only the recommended and supplied tools to clean the scanner.
WARNING: Do not use any solvents or corrosive liquid (i.e., alcohol, kerosene, etc.) to clean any part of the scanner.
Otherwise the plastic material may be permanently damaged.
Clean the Outer Casing
1. Use a suitable dust blower to blow off the dust on the scanner.
2. Use a slightly dampened cloth to wipe off any smears on the surface of the scanner.
3. Wipe the scanner with a dry and clean lint-free cloth.
Clean the Image Sensor
1. Clean the scanner's outer casing first.
20 Customer Support: http://www.pandigital.net/kodaksupport
All manuals and user guides at all-guides.com
to install and the follow the on-screen instructions.
www.kodak.com
2. With the scanner powered off and disconnected from the power supply, insert the
sensor cleaning swab into one end of the output slot.
 Make sure that there is no visible dust on the swab before inserting it into the output
slot
3. Gently slide the sensor cleaning swab back and forth from one end of the output slot to
the other five or six times consecutively.
CAUTION: Do not apply too much force on the swab.
for complete usage instructions.