Machine Installation; Uncrating Machine; Installing Batteries - Nobles SPEED SCRUB 1701 PLUS Manuel Opérateur

MACHINE INSTALLATION

UNCRATING MACHINE

Carefully check carton for signs of damage. Report
any damage at once to carrier.
Check Machine Contents to ensure package is
complete. Contact distributor for missing items.
Machine Contents:
1 -- Battery Cable #602871
1 -- Wire Asm. #6X24" Black #603208
2 -- 12VDC 130AH Batteries #130869 (included with
machine PAC)
1 -- Battery Charger, 24V/15A 120V #603553 (included
with machine PAC)
To uncrate your machine, remove shipping straps and
carefully lift or make a ramp to remove machine from
pallet. Do not roll machine off pallet, damage may
result.
FOR SAFETY: Get assistance when lifting
machine. Do not lift machine when batteries are
installed.
Raise scrub head to transport position before
maneuvering machine. Step down firmly on scrub
head lift pedal to raise (Figure 1).
NOTE: To prevent scrub head skirt damage, always
keep machine in transport position when pad driver is
not installed.
FIG. 1
ATTENTION: Do not roll machine off pallet,
damage may occur.
ATTENTION: To prevent possible machine
damage, install batteries AFTER removing
machine from shipping pallet.
Speed Scrub 1701 Plus (04- -07)
Home Find... Go To..
Squeegee assembly is packaged with machine.
Batteries, battery charger, brush, pad driver and pads
must be purchased separately. Consult an authorized
distributor for specific pads and brushes.
ATTENTION: The use of supplies other than those
recommended by manufacturer may cause
damage.

INSTALLING BATTERIES

WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Compartment
Open When Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries or battery cables. Avoid contact
with battery acid.
Battery Specifications:
Two 12 volt, deep cycle batteries. Consult with an
Authorized Distributor for specific batteries. Maximum
battery dimensions are 178mm (7 in.) W x 330mm
(13 in.) L x 254mm (10 in.) H.
1. Park machine on a level surface, turn off all
switches, and remove key.
2. Remove battery hood to access battery
compartment. Then remove metal battery tray and
loose battery cable from compartment.
3. Disconnect vacuum hose from recovery tank
snout. Carefully install bottom battery into
compartment with battery posts positioned
towards rear of machine (Figure 2).
FIG. 2
ATTENTION: Do not drop battery into
compartment, battery and machine housing
damage may result. This damage is not covered
by warranty.
4. Connect red battery cable coming from machine to
positive (+) post of bottom battery. Then connect
black jumper cable to negative (--) post (Figure 4).
OPERATION
7