• The appliance's power network must be equipped with a suitable
omnipolar disconnection device compliant with national installation
regulations.
• The appliance is powered solely through a socket compatible with the plug provided.
CAUTION
Any replacement of the power cable must be carried out solely by Olimpia Splen-
did technical support or by similarly qualified personnel.
2.6 - DRAINAGE
depending on the modality of use of the appliance, it is necessary to connect the condensation discharge pipe.
2.6.a - Use as dehumidifier
For the correct use of the appliance, work as follows (figures 15 and 16):
a. remove the cap (28).
b. insert the supplied pipe (12) in the connector.
Make sure the end of the discharge pipe (12) is positioned on a drain well or in a container.
Make sure the pipe (12) is not clogged.
3 - USE OF THE APPLIANCE
the functioning modes if the air conditioner can be selected both through the remote control and through the
control panel located on board of the air conditioner.
The reception of the selected function is confirmed by the emission of a "beep" by the buzzer.
3.1 - CONTROL PANEL SYMbOLS AND KEYS
b
SW2
• SW1:
running / Stand-by;
• SW2: Working mode selection
cooling =˃
=˃ automatic =˃
=˃ fan only =˃
=˃ dehumidification =˃
=˃ cooling =˃...
EN - 20
SW4
S5
S3
S4
S1 S2
(Fig.b)
D1
SW3
• SW3: temperature/delay set increase;
• SW4: temperature/delay set decrease;
• S1:
Standby mode.
• D1:
tset/timer
• S2:
timer mode;
• S3:
Cooling mode;
• S4: Dehumidification mode;
• S5:
Ventilation mode.
SW1