Connection To Flue Pipe - Palazzetti SPHERA IDRO Notice D'installation

A PERFECT DRAUGHT
that is clear of obstructions such as chokes, horizontal
sections or corners; any axial displacements should be
at a maximum angle of 45° compared to the vertical axis,
(better still if it is only 30°).
The CHIMNEY TOP shall be the WINDPROOF type
with an inside cross section equivalent to that of the
DOUBLE
To avoid draught problems, each stove should have
been used it should be cleaned thoroughly to avoid
malfunctions and the danger of unburned parts deposited
system through wooden walls or ceilings; in such cases
6.5

CONNECTION TO FLUE PIPE

with EN 13384-1.
The SMOKE
should have the same cross section as the stove's smoke
In order to connect the stove to the chimney you may
perform maximum 3 changes of direction that should not
exceed 90°, the fume duct should not exceed 2 metres
in length and 3 metres in total (- 6.1 -).
if the outlet is placed on the ceiling, make sure that the
the direction.
Follow the indications in the technical data sheet
regarding the chimney draught value.
INSTALLATION
.
x
y
- 6.1 -