Cont; Continuous Printing; Piece = Parts Counting - Adam Equipment AELP Notice Utilisation

cont = CONTINUOUS PRINTING
6.5
This parameter is used to configure to print continuously whenever
there is any weight on the balance or only when [Print] is pressed.
• To set the parameter press the [Func] key to show "cont"
• Press [Print] to see the parameter.
• Press [Print] to select either "cont= 0" or "cont= 1".

"cont= 0"

"cont= 1"
• Press the [Func] key to return to weighing.

PIECE = PARTS COUNTING

6.6
• Parts counting is used to display the number of items placed on
the balance after a sample of the items is used to calibrate the
balance.
• Place a container on the pan and press [Tare] to zero the display.
Place a quantity of items to be counted in the container. The
number of items is the sample size.
• To enter parts counting mode, press the [Func] key until "PIECE" is
displayed.
• Press [Print] to enter parts counting mode. The sample size is
displayed. To select a different sample size use the [Tare] key to
select a digit and the [Print] key to increment the value. The
sample size can be set in the range of 1 to 100,000.
• When the desired sample size is shown, press the [Func] key.
• The display will show "LOAd". If the sample is not already on the
pan, place it now.
• Press the [Func] key.
• The display will show the number of items in the sample. The
display may show "contr" briefly while it is computing the number
© Adam Equipment Company 2005
Continuous output is disabled. Prints only when the
[Print] key is pressed.
Continuous printing is enabled.
10