Adjusting Your Body Position - Vermeiren LiNX 200 Manuel D'utilisation

EN
NL

4.6 Adjusting your body position

CAUTION
 Be aware that the stability decreases when the wheelchair is moved from sitting
straight to inclined position.
 Make sure that there is enough space around the wheelchair to operate the backrest
and seat.
The wheelchair's adjusting functions can be operated using the adjusting function button.
Depending on your type of wheelchair, there can be up to 6 functions.

Press the top of the button to select the next adjusting function. Press the
bottom of the button to select the previous adjusting function.

To adjust your body position, move the joystick to the front or back.

To return to the basic sitting position, move the joystick to the back for each
adjusting movement.
The selected adjusting function is displayed on the actuator status indicator as shown
below. The display only shows the available/programmed functions in your wheelchair.
 To lock the system: press and hold the power button for 7 seconds.
When entering the locked state, the battery gauge will indicate the
transition by flashing LED's 1, 3, and 5 (far left, middle, and far right) 3 times.
 To unlock the system: press the power button once, and then press the
horn button twice — the horn button must be pressed twice within 10
seconds of pressing the power button.
If the user does not execute the unlock sequence correctly, within the
required time frame, or the power button is pressed again before the
unlock sequence is complete, the system will return to the locked state.
During an unlock attempt, the battery gauge will indicate that the system is
in a locked state by flashing LED's 1, 3, and 5 (far left, middle, and far right)
until either the system is powered off, unlocked, or until the sequence
timeout of ±10s is reached and the controller switches off automatically.
Risk of injuries or damage
Figure 4
10
LiNX 200
2019-01
Operating console functions
Position adjustment button