Vermeiren LiNX 200 Manuel D'utilisation page 12

EN
NL
Display
4.3.1 Charging

Driving is prevented (inhibited) while the system is being charged.

Charging is possible without switching the operating console ON. To see the
battery status indicator, switch it ON.
Plug the battery charger into the remote's XLR socket (12),
see Figure 1.
The battery charger indicator will indicate the system is
being charged by cycling between a left to right chase
sequence, and then displaying the approximate battery
charge state at the end of the chase sequence.
Description
Only red and amber LED's
lit.
Red and amber LED's lit.
Only Red LED lit.
1 Red Led is flashing.
First red LED flashes on
the battery indicator.
The status indicator will
display a flash code 2 or 7.
The horn will sound once
every 10 seconds.
Meaning
Low battery level.
Very low battery level.
Battery almost empty.
Battery empty.
Low voltage warning:
battery voltage level
decreased below its low
voltage warning set-point.
Battery voltage decreases
below the battery cut-off
voltage.
Figure 2
8
LiNX 200
2019-01
Operating console functions
Remarks
Battery half full. Start the
return journey.
Battery low (between 0 and
20% of full capacity).
Recharge soon.
Recharge now.
Recharge immediately.
Battery is fully discharged,
and it is good practice to
stop discharge at this point.
The display and wheelchair
shut down automatically.
Battery-charging indication