Before Use; General Safety Instructions - Vermeiren LiNX 200 Manuel D'utilisation

EN
NL
2

Before use

WARNING
 Do NOT install, maintain or use this product unless you have read and fully
understood all instructions in this manual and all relevant manuals regarding the
wheelchair equipped with this product.
 Do not try to open or disassemble the console in any case - there are no user -
serviceable parts inside.
 In case of doubts or questions, do not hesitate to contact your local specialist dealer,
your care provider, or your technical adviser to help you with this.
Vermeiren is responsible for software updates/repairs. For adaptations in the
software contact Vermeiren, see our website

2.1 General safety instructions

Keep the following general warnings in mind during use:

The operating consoles have been tested for electromagnetic compatibility on typical,
representative vehicles and comply with the appropriate EMC standards:
EN 12184: 2014, ISO7176-21: 2009. Nevertheless, sources of electromagnetic field
may influence the driving performance of your wheelchair, like the fields of mobile
phones, power generators or high-power energy sources. On the other hand, the
electronics of your wheelchair can affect other electronic appliances too, like alarm
systems of shops and automatic doors. We therefore advise you to check your
operating console / wheelchair regularly for damage and wear, since these may
enlarge the interference.

Be aware that the surface of the operating console may get very hot due to solar
radiation or heating devices. Be careful when touching.

Make sure that the controller does not become colder or hotter than the allowed
minimum and maximum temperature, see the wheelchair user manual.

Before switching the wheelchair on, be aware of your environment/situation. Adjust
your speed accordingly before driving off. We advise you to use the slowest speed
setting to drive indoors. For outdoor driving you can adjust the speed to a suitable
speed at which you feel comfortable and safe.

Do not touch the connector pins. If you touch the pins, they can become dirty, or they
can be damaged by electrostatic discharge.

If the wheelchair has not been fitted with a hand guard for the operating console, be
aware that your hand will not be protected from crushing, for example while
manoeuvring towards a table.
Risk of injuries and damage
http://www.vermeiren.com/
4
LiNX 200
2019-01
Before use