Night Function - FUAVE ACG12K02 Manuel D'instructions

6. Night function

• Press on the 'Mode' button until the 'Cool' light shows on the display.
• Set the required temperature.
• Press the 'Sleep' button, after 1 hour the temperature is reduced by 1°C
and after 2 hours increased by 2°C.
• The device continues operating in this mode.
• By pressing the 'sleep' button again you switch of the function.
7. LED display
The display shows the configured temperature or the timer settings. The
display also shows the error codes, see further on in this manual.
Additional comments
• When you start the device and opt for a specific function or change
function, the ventilator will work but the compressor will not start
immediately: the latter to protect the internal components. The symbol
that belongs to the configured function blinks on the display, a sign of
the 'waiting mode'. This can last 3 to 4 minutes.
• In case of prolonged strong cooling, ice accretion can occur on the
interior of the device. You notice this because the device performs less.
To solve this you switch off the device and give it time to defrost.
• When there quired cooling or heating temperature has been attained,
the device will continue ventilating but the compressor
discontinues operating.
41