Cooling Function - FUAVE ACB12K02 Manuel D'instructions

Before using the air conditioner, check:
• That it has been installed according to safety instructions.
• That it is not damaged or broken.
• That the electrical socket that you wish to use has the same voltage as is
given on the unit's specification plate (220-240V~50Hz).
• That no other devices are connected to the same socket.
If this has all been checked, you can insert the plug into the socket.
• Switch the device on with the 'power' button.

1. Cooling function

• Press the 'Mode' button until the 'Cool' lamp is shown on the display.
• The display shows 25°C.
• Set the required temperature with the Temp+/Temp- button. The
display shows the configured temperature. The temperature can be set
between 16 and 31°C.
• Press the 'Speed' button to set the ventilator speed at low or high.
• Observe an interval of at least 3 minutes between every on/off.
2. Dehumidification function
• Press the 'Mode' button until the 'Dehum' lamp is shown on the display.
• Check if the water discharge high is connected correctly.
• The display automatically shows 2°C below the room temperature.
• The temperature cannot be changed.
• The ventilator speed is automatically set to normal.
• Observe an interval of at least 3 minutes between every on/off.
38