Cleaning And Maintenance; Cleaning The Housing - FUAVE ACG12K02 Manuel D'instructions

SAFETY
The device is fitted with an overheating safeguard that switches the unit
off if it overheats. If this should occur, you must remove the plug from the
socket and leave the equipment to cool for at least 30 minutes. Remove the
cause of overheating - has the device been (partially) covered? Is it too close
to a wall or another obstacle, preventing it sucking in or dispelling sufficient
air? You can then use the device normally again but keep an eye on it for
the first 30 minutes to ensure there are no further problems. If the device is
showing signs of problems or the overheating recurs, even though there is
no obvious assignable cause, ask your supplier or a recognised electrician
to check/repair the unit.

CLEANING AND MAINTENANCE

Note! Before cleaning or carrying out maintenance work on the air
conditioning unit, always switch off and remove the plug from the socket!
Regular cleaning is vital in order to keep the unit in good working order!

Cleaning the housing

Always remove the plug from the socket before cleaning the housing.
Wipe the cabinet with a clean, soft, lint-free cloth or soft brush. Do not
use aggressive cleaning agents, scouring pads or brushes and no chemical
cleaning agents; this can damage the material. Never use flammable
cleaning agents such as benzene or methylated spirits. Let the device dry
completely before using it again. Never immerse the plug, electric cable or
any part of the appliance in water or any other liquid. This can lead to an
electric shock!
43