Rizzoli RE 40 Manuel D'utilisation page 110

STANDARD SHEET
Model
RE 40 - RVE 40
RE 45 - RVE 45
RE 50 - RVE 50
RI 60 - RVI 60
Table 2a – Minimum and maximum distances from the centre
of the hole of the flue outlet. It is not considered
the tolerance generated by the bayonet fitting.
EXTRA SHEET (OPTIONAL)
F
min
X - 20
Table 2b – Minimum and maximum distance from the centre of
F
the hole with the extra sheet. It is not considered
the tolerance generated by the bayonet fitting.
On demand it is possible to order an extra sheet able to fill
an intermediate interval for the rear flue outlet. When or-
dering, it must be defined the base position (X). The excur-
sion of the sheet allows a variation of the position of ± 20
mm horizontally.
2.13 ADJUSTABLE REAR FLUE OUTLET
(COOKERS WITH OVEN, RE 100 AND RVE 100 EXCLUDED)
On most models with oven it is possible to change
the position of the rear flue outlet. The move-
ment can be done both horizontally and vertical-
ly, in order to connect more easily the pipe to the
chimney hood. For the horizontal regulation, it is
necessary to unscrew the 8 screws sustaining the
external sheet and then screw again them when
the flue outlet is in the chosen position. On some
models, it is possible to obtain further regulations
F F
min standard max
115 135 155
115 135 155
115 135 155
165 185 205
F F
F
max
X X + 20
108
F
F
Picture 13a – Rear sight of the cooker and
representation of the minimum
and maximum movement of
the rear flue outlet position
with standard sheet.
F
Picture 13b – Rear sight of the cooker and
representation of the mini-
mum and maximum movement
of the rear flue outlet position
with extra sheet.
removing and tilting the sheet (see picture 14b).
On demand, Rizzoli can provide an extra sheet to
be used in the intermediate positions of the sheet.
For both the horizontal and the vertical regulations
there is a tolerance of 1 cm thanks to the provided
bayonet fitting as described in paragraph 2.11.
In the following tables are reported, for each mod-
el with oven, the minimum and maximum dimen-
sions (in mm) of the distances from the centre of
F