Float Valve - DriSteem Vaporstream Mode D'emploi

This service kit contains the replacement parts called out in the
parts drawing to keep your DRI‑STEEM humidifier operating
at peak performance. This Service Kit Manual provides
important safety and service instructions; it is intended to
supplement — not replace — the humidifier's Installation,
Operation, and Maintenance Manual. Please see Read all
warnings and instructions on page 1.
While performing service and maintenance procedures,
replace existing parts with the new parts provided in the
service kit.
Notes:
• P arts for both standard water and
DI water humidifiers are shown.
• C omponents may by oriented
differently than shown in drawing.
Apply clear silicone (2) to both sides of gasket.
7
Va p o r s t r e a m , D I W a t e r, s e r v i c e k i t p a r t s
mc_052808_1400
6
DRI-STEEM Vaporstream Electric Humidifier, DI Water, Service Kit Manual • Page 3

Float Valve

Put back-up washer on
arm first, then seat (8).
Insert cotter pin
4
5
1
Torque to 25 to 35 in-lbs (2.8 to 4.0 N-m).
8 Valve
Arm
OM-863-1
mc_051908_1410
3
See Float Valve inset.
VLC-OM-033X
mc_052708_0835