Sonnenkonig 2100 Mode D'emploi page 41

5.
Carefully unplug the power cord as far
as possible from the base. Attach the
power cord under the weighted base
using the 4 M4 nuts supplied.
6.
Raise or lower the top tube to the
desired height and tighten it with the
middle tube by turning the knob.
7.
Fix the heater to the floor. Drill three
holes in the floor, fix the heater to the
floor with three wedge screws and
tighten with a wrench.
1. Lower rod
2. Wedge screw
3. Mounting plate
4. Base
5.
Carefully unplug the power cord as far
as possible from the base. Attach the
power cord under the weighted base
using the 4 M4 nuts supplied.
6.
Raise or lower the top tube to the
desired height and tighten it with the
middle tube by turning the knob.
7.
Fix the heater to the floor. Drill three
holes in the floor, fix the heater to the
floor with three wedge screws and
tighten with a wrench.
1. Lower rod
1.
2. Wedge screw
3. Mounting plate
2.
4. Base
3.
4.
41
EN
1.
2.
3.
4.