Functions - Trix 232 Serie Mode D'emploi

Functions

• An electronic overload protektion is build in to pro-
tect the model.
• Built-in electronic circuit for oberation with an
conventional DC power pack, Trix Selectrix or NMRA
DCC digital.
• Triple headlights that change over with the direction
of travel.
• Automatic system recognition between digital and
analog operation.
• No automatic system recognition between Selectrix
(SX) and DCC.
• The full range of functions is only available under
Selectrix 2 (SX2) and under DCC.
• Analog 14 volts DC, digital 22 volts AC.
Notes on digital operation:
• The first time the locomotive is used in a digital
system (Selectrix or DCC), the decoder must be set
for this digital system. To do this, the decoder must
be programmed once in this digital system.
• The operating instructions for your central unit will
give you exact procedures for setting the different
parameters.
• The values set at the factory have been selected to
insure trouble-free operation.
• This locomotive comes from the factory programmed
for the digital address „01" (Selectrix) / „03" (DCC).
• This locomotive with the settings made at the factory
cannot be operated with opposed polarity DC power
in braking track blocks. If this feature is desired, then
you must do without conventional DC operation
(CV 29 / bit 2=0).
6
• Function:
Headlights
Operating Sounds
Horn (long blast))
Engine Coolers
Horn (short blast)
Coupler Sounds
Note for Selectrix Operation:
When a train enters a braking block that is turned on,
and enters it against the direction of travel, the indicator
light for running trains goes out in the braking block.
After the bracing block, the running light indicator
comes back on.
Safety Warnings
• The locomotives making up this model are perma-
nently coupled together and cannot be separated or
run individually.
• The locomotive must not be connected to more than
one power source al a time.
• Pay close attention to the safty warnings in the
instructions for your operating system.
• Not suitable for locomotive controllers with pulse
width control.
• Not suitable for continuous train lighting on
analog layouts.
• Not suitable for Trix ems.
SX1 SX2 DCC
Head- Head-
F0
lights lights
Func. F1 F1
– F2 F2
– F3 F3
– F4 F4
– F5 F5