Installation Of Motor On Section Bar - Erreka AZIMUT Mode D'emploi

INSTALLATION OF GUIDE
SECTION BAR
1. Remove the section bar from its
cardboard packaging and check its
integrity.
2. Unfold the section bar as indicated in
the figure below.
3. Once the section bar is elongated, slide
the connecting section bar R to the end
position indicated by the two holes Q
on the chain-guide section bar.
4. Adjust the tension of the chain using the
Allen-head screw with a 10 mm
Allen-wrench: turn the bolt until the
chain is sufficiently tight.
CAUTION: Make certain that the
draw slide slides freely along the entire
length of the guide. Eliminate any
friction prior to proceeding with the
next phases of installation.
INSTALLATION OF MOTOR
ON SECTION BAR
1. Insert the shaft/pinion adapter on the motor shaft.
2. Position the section bar A on the motor:
the shaft/pinion adapter B must fit into the seat on the
section bar. Verify that the section bar fits snuggly
against the motor.
3. Position the two omega brackets C on the section bar
so that they correspond with the holes on the base of
the motor.
4. Fasten the two omega brackets using the 6 x 15
self-threading screws provided D.
In case of lack of space, the motor can be
mounted rotated of 90°
28