Erreka AZIMUT Mode D'emploi page 31

INSTALLATION
2.1 Disassemble the door's locking system.
2.2 Measure the door, and at exactly half its height mark the
reference points on the upper crossbeam and on the ceiling
to facilitate positioning of the guide section bar.
2.3 Fasten the bracket E to the upper crossbeam of the door
using plugs G suitable for the type of wall (ø minimum
8 mm).
2.4 Affix section A to the bracket using the 6x80 round-head
screw F and the self-locking nut provided.
2.5 Attach the two fixing supports H to section A, positioning
them approx. 1 m from the bracket E
2.6 Attach bracket I, positioning it close to the motor
(approx. 5 cm)
2.7 Following the reference points previously traced out on the
ceiling, identify the fixing points for the supports H and the
bracket I; drill out the holes and using rawplugs suited to
the ceiling type (minimum diameter 8 mm), fix the
automation device.
2.8 Use the special drilled bars Q (accessory code AAZ03)
should it be necessary to adjust the height of the
automation device.
Assemble the bars as shown in the following figure.
PLEASE NOTE: the maximum distance between the
fixing piece and the ceiling must not exceed 300 mm
2.9 Only for sectional and spring operated garage doors
Fasten the draw slide I on the upper portion of the door
maintaining the previously marked reference points.
Connect the perforated bar L and the curved arm M using
2, 6 x 15 bolts. Connect the curved arm M and the draw
plate I using the cylindrical headed pivot with the provided
split pin.
29