Elements Of The Complete Installation - Erreka VIVO-I103 Guide Rapide

VIVO-I103(M)/ VIVO-I203(M)
Quick installation and programming guide
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
other explanations which must be taken into account. You can download the installation manual in the
WARNING
"Downloads" section of the Erreka website:
http://www.erreka-automation.com
NOTE: this control panel is valid
for operators for the following
types of door and gate:
swing (C301),
sliding (C302),
up-and-over (C303).
Electrical wiring
A: Main power supply
B/F: Flashing light with antenna
C: Photocells (Rx/Tx)
D: Key switch
E: Operator
VERY IMPORTANT: the TC closing stopper and the TA
opening stoppers must be installed.
Power supply and peripheral cabling (valid for all cases)
JP1
M
230V
3~
Pos 1
M
230V
1~
Pos 2
EPS1: traffic light card
(with parameter Ab00) or
b r a k e c a r d ( w i t h
p a r a m e t e r A b 0 1 , s e e
connection diagram on
p a g e 2 0 ) . S e e o t h e r
options on page 24.
See the Display
indications on
page 20.
F1: 3A fuse
F2: 0.5A fuse
DL27: LED Continuous
Bus

Elements of the complete installation

Rx:
TA
A.T./A.
S.EXT./
S.CIE.
A.P./C.
S.INT./
S.APE.
TC
Tx:
TA
JP1
English
E241B
F2
F1
DL27
VIVO-I203:
(resistive)
230V, 50-60Hz
VIVO-I203M:
125V, 50-60Hz
(resistive)
17
P294Z2