Display Messages - Erreka AZIMUT Mode D'emploi

MEMORISING REMOTE CONTROL UNITS
The device can memorise up to 15 remote control units. To memorise a remote control unit, proceed as follows:
Press the key
CAUTION: When selecting decoding type (F: Fixed Code / r: Roller Code /r.: Personalised Roller Code) in order to control
automation, see paragraph "5. Selecting remote control decoding type".
DELETING REMOTE CONTROL UNITS
Press and hold key :

DISPLAY MESSAGES

Display Reason
The display shows the letter L when the actuator is working normally and the red cam positioned on the chain activates
L
the micro switch on the motor
F The display shows the letter F when the door encounters an obstacle
H The display shows the letter H when the encoder or the control unit is malfunctioning
A The display shows the letter A when the photocell intervenes
F r r.
, or is then
displayed on screen after
around one second.
F r r.
, or is then
displayed on screen after
around one second.
Release the key and press the remote control button
twice: the device emits a BEEP and the display is turned
off to confirm memorising has been successful
Hold the key until the display is turned off : the remote
controls have been deleted.
35