Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.1.1 Exchangeable thermoblocks for micro test tubes
(microcentrifuge / cryogenic / microtubes)
1. Place the exchangeable thermoblock (2) on the thermosocket with
both flat edges and the writing facing the front.
2. Tighten the captive screws (1).
4.1.2 Exchangeable thermoblock for Multiwell Plates /
Deepwell Plates
Caution! Microplates melt at extremely high temperatures.
Only heat microplates made of polystyrene to a maximum
i
70 °C.
1.
Insert the short screws in the MTP exchangeable thermoblock with
the flat washers.
2.
Secure the screws from below using the lock washers.
The lock washers prevent the screws from falling out of the bores
if the exchangeable thermoblock is not fixed on the unit.
3.
Place the MTP thermoblock on the device in such a way that the
spring plate is to the front left.
4.
Tighten the screws.
1
2
Thermoblocks for Mixer HC · User Manual · 5
Publicité
Table des Matières
