Intended Use - StarLab S8012-0018 Mode D'emploi

3 INTENDED USE

The exchangeable thermoblocks are intended exclusively for indoor use to
hold tubes and plates during sample preparation.
The exchangeable thermoblocks must only be operated by appropriately
qualified and instructed personnel. Carefully read the operating manual
before working with the exchangeable thermoblocks and familiarize
yourself with their use.
4 INSTALLATION AND OPERATION
4.1 Mounting exchangeable thermoblocks
Warning! Risk of burns from hot surfaces.
The exchangeable thermoblock and the thermal base can be very
hot after heating and cause burns.
Allow heated exchangeable thermoblocks and the thermal
i
base to cool down completely before removing the exchange-
able thermoblock.
Warning! Injury or property damage from improperly attached
exchangeable thermoblocks.
If the exchangeable thermoblocks are not attached properly, they
can become detached from the device or break.
Tighten the screws of the exchangeable thermoblocks so they
i
are hand-tight.
Warning! Contamination due to opening tube lids.
In the following cases, the lids of tubes can spring open and the
sample material can escape:
high vapor pressure of the content,
•
improperly sealed lid,
•
damaged sealing lip.
•
Always check that all tubes have been sealed tightly before
i
use.
To insert the exchangeable thermoblocks, use the accessories
supplied (eg. screw driver, screws, flat washers and lock washers).
4 · Thermoblocks for Mixer HC · User Manual