Wand Selection; System Shut Down; System Storage And Transport; Equipment Disposal - smith&nephew ArthroCare Atlas Manuel De L'opérateur

Wand Selection

Select the Wand type most appropriate for the procedure. The Controller will preset nominal and maximum ablation
set points for each Wand style to as a guide for safe and effective operation.
NOTE: Initial and maximum Set Points are suggested settings. Proper activation of the Wand should always be con-
firmed.
In order to adjust the ablation set points, the Wand and Patient Cable must be connected to the Controller.

System Shut Down

1. Turn the power switch to the 'OFF' position. After a brief (less than 4 seconds) delay, all lights on the Controller
and the Set Point Display will go off.
2. Disconnect the suction tubing if appropriate.
3. If using the reusable Patient Cable, remove the Wand from the Patient Cable and disconnect the Patient Cable
from the Controller. Dispose of the Wand and prepare the Patient Cable for sterilization and further use.
4. If using the ArthroWand with Integrated Cable, disconnect the Wand cable connector from the Controller. Do not
attempt to separate the ArthroWand from the Cable component. Discard the Wand with Integrated Cable.

System Storage and Transport

All ArthroCare Atlas System components may be safely stored and transported at an ambient temperature range of -
40°C (-40° F) to +70°C (158° F). The relative humidity should be between 10 and 85%.

Equipment Disposal

The ArthroCare Atlas System contains electronic printed circuit board assemblies. It should be disposed of in accor-
dance with any applicable national or institutional policies relating to obsolete electronic equipment. Dispose of the
Wand, Wand with Integrated Cable, and the Patient Cable according to normal institutional practices for potentially
contaminated items.
19
ArthroCare Atlas™ System
®
User's Manual