Alarms - smith&nephew ArthroCare Atlas Manuel De L'opérateur

9. Foot Control / Hand Control Receptacle
The Foot Control / Hand Control plugs into the tan receptacle located on the front of the Controller.
10. Symbol for Defibrillator-Proof Type BF Equipment
This equipment provides a degree of protection against electric shock to TYPE BF applied parts as defined in
IEC 601-1, it also has an F type applied part capable of withstanding the effects of defibrillator discharge.
11. Black Cable Receptacle
The Cable Receptacle with the black ring will accept ICWs with black mating end.
12. Tan Cable Receptacle
The Cable Receptacle with the tan ring will accept the reusable Patient Cable and ICWs with gray mating end.
13. Sliding Door
This door slides left and right and allows access to either the Black Cable Receptacle or the Tan Cable
Receptacle.
BACK PANEL
14. Tone Volume Control
The Tone Volume Control regulates tone volume. To increase volume, turn the knob clockwise. To reduce vol-
ume, turn the knob counterclockwise.
15. Non-Ionizing Radiation Symbol
This symbol indicates that this equipment intentionally emits RF energy during activation.
16. Fuse Rating Symbol
This symbol indicates that only fuses with the appropriate rating should be used. Check the Controller back label
for the appropriate fuse rating. See Maintenance and Troubleshooting section for fuse replacement instructions.
17. Power Cord Receptacle / Fuse Holder
The Controller Power Cord plugs into this receptacle. The fuse holder is behind the receptacle.
18. Equipotential Ground Symbol
This symbol identifies the conductor that is used to bond the equipment to earth ground.
19. CE Mark - European Certification Symbol
This indicates compliance with the European Commission Medical Device Directive (93/42/EEC).
20. Attention Symbol
This symbol alerts the user to read and understand this manual and accompanying instructions before operating
the equipment.
21. Auxiliary Input
For manufacturer use only.

Alarms

1. Intermittent dual tone:
2. Intermittent monotone:
current limit alarm or overload
connection fault alarm (Patient Cable, Wand, Integrated Cable Wand, Over
Temperature Condition, Over Power Condition)
13
ArthroCare Atlas™ System
®
User's Manual