Using The Cooler - Mobicool MCG15 Notice D'utilisation

Masquer les pouces Voir aussi pour MCG15:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35
Operation
The device is equipped with a multi-level battery monitor that protects your
vehicle battery against excessive discharging when the device is connected
to the on-board DC supply.
If the cooler is operated when the vehicle ignition is switched off, the cooler
switches off automatically as soon as the supply voltage falls below a set
level. The cooler will switch back on once the battery has been recharged to
the restart voltage level.
Switch-off voltage at 12 V
Restart-voltage at 12 V
Switch-off voltage at 24 V
Restart voltage at 24 V
6.5

Using the cooler

A
NOTICE! Damage hazard
Failure to obey this instruction may result in damage to the device.
Ensure at all times that there is sufficient ventilation so that the
heat that generated during operation can dissipate. Ensure that
the ventilation slots are not covered. Make sure that the device
is sufficiently far away from walls and other objects so that the
air can circulate. We recommend keeping a gap of at least 50 mm
around ventilation holes.
➤ Place the cooler on a firm foundation.
I
NOTE
Place the cooler as shown (fig. 1, page 3). If you operate the
cooler in a different orientation it can be damaged.
➤ Connect the cooler (chapter "Connecting the cooler" on page 11).
✔ The cooler starts cooling the interior.
A
NOTICE! EXCESSIVELY LOW TEMPERATURE HAZARD
Failure to obey this instruction may result in damage to the objects
placed in the cooler.
Ensure that only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
12
MCG15
11 V
12 V
21.5 V
23.0 V
EN

Publicité

Table des Matières
loading

Table des Matières