Troubleshooting - Mobicool MCG15 Notice D'utilisation

Troubleshooting

8 Troubleshooting
Fault
Device does not
function (DC plug is
inserted).
Device does not
function (AC plug is
inserted).
The display shows
an error message
(e.g. "E1") and the
device does not
cool.
16
Possible cause
There is no voltage
present in the DC
power socket.
Defective compressor. This can only be repaired by an
Voltage of the vehi-
cle battery is too low.
The DC power socket
is dirty. This results in
a poor electrical con-
tact.
The fuse of the DC
plug has blown.
The vehicle fuse has
blown.
There is no voltage
present in the AC
power socket.
Defective compressor. This can only be repaired by an
The AC power socket
is dirty. This results in
a poor electrical con-
tact.
The device has
switched off due to an
internal fault.
Suggested remedy
The ignition must be switched on in
most vehicles to apply current to the
DC power socket.
authorised repair centre.
Test the vehicle battery and charge it
as needed.
If the plug of your cooler becomes
very warm in the DC power socket,
either the DC power socket must be
cleaned or the plug has not been
assembled correctly.
Replace the fuse (8 A) in the DC plug,
see chapter "Replacing the fuse" on
page 14.
Replace the vehicle's DC power
socket fuse. Please refer to your vehi-
cle's operating manual.
Make sure the connection for AC
plug is good.
authorised repair centre.
If the plug of your cooler becomes
very warm in the AC power socket,
either the AC power socket must be
cleaned or the plug has not been
assembled correctly.
This can only be repaired by an
authorised repair centre.
MCG15
EN