Bühler technologies Smart-Sample-Tube Notice De Montage page 9

Smart-Sample-Tube
5.2 Operating the sample gas probe
When all requirements for startup are met, the probe plug
can be connected to power.
The desired sample tube temperature can be set on the ther-
mostat in the middle of the front panel using a slot screw-
driver. The position of the flat side on the adjusting shaft in-
dicates the set value.
Flat side down = heater off
Flat side up = heater set to approx. 125
°C (257 °F)
Flat side on right = heater set to ap-
prox. 185 °C (365 °F)
The heater is variable and can also be
set to other temperatures. To reduce
turn anti-clockwise, to increase turn
clockwise.
The heating phases are indicated by
the status LED lighting up. When the
set temperature is reached, the status
LED goes out.
The LED regularly switching on and
off indicates the heating phase is lev-
elling off.
6 Maintenance
Always observe the applicable safety- and operating regula-
tions when performing any type of maintenance. Please refer
to the original operator's manual on the included CD or online
at www.buehler-technologies.com for maintenance informa-
tion.
7 Service and Repair
Please refer to the original operator's manual on the included
CD or online at www.buehler-technologies.com for a detailed
description of the unit including information on
troubleshooting and repair.
BX464009 ◦ 10/2021 Bühler Technologies GmbH 9