Percent Weighing - Adam Equipment CBK Serie Mode D'emploi

EN
displayed. The display shows
"rEC X"
to be recalled.
recalled. The indicator will change to the recalled limits, weighing units and settings for the beeper and bar
graph.
NOTE:
If the recalled limit is for parts counting or percent weighing, the display will show the last sample
value used, ready for a new sample to be counted. If the memory location was empty the scale will return to
weighing.
2.7

PERCENT WEIGHING

The scale will use a mass on the platform as the 100% reference weight or input a reference weight using the
keypad.
Steps:
Press [Func]. The first option is
displayed. Press [Tare] again to enter percent weighing. Put the sample on the
platform. The scale will set the sample mass on the platform as 100% reference
weight.
NOTE:
If there is no reference weight on the pan and percent weighing function is
entered, pressing [Tare] again will return to normal weighing.
Remove the sample weight. Then any other weight placed on the platform will be displayed as a percentage
of the original sample.
The number of decimal points will depend on the weight used. A smaller weight will show only "100%" while a
larger weight might show "100.00%".
If the scale is showing zero When entering this function, Users can also input the reference weight using the
keypad, press [Tare] to accept the reference weight. The display will show "0.00 %".
"x x . x x %"
If the indicator shows
the numeric keypad to enter a new value. Press [Tare] to accept the new reference weight.
Press [Unit] to return to normal weighing.
NOTE:
1) The weight entered must be greater than 50 scale divisions.
2) The display may jump by large numbers unexpectedly if small weights are used to set as 100%
reference. For example, if only 23.5g is placed on a scale with 0.5g increments and is set to 100%,
the display will show 100.00%. However a small change of weight will cause the display to jump to
102.13% as an increase of one scale division (0.5g) to 24.0g will be equivalent to an increase of
2.13%.
© Adam Equipment Company 2017
"rEC"
. Enter the number corresponding to the desired memory location (0 to 9)
will be displayed for 2 seconds indicating the values stored in the location "X" is being
"FUnC 1"
, Press the [Tare] key.
, which is the last weight used as a reference, press [CE] to clear and use
"F1 PCt"
5
will be